Install receiver firmware

Open this page on a computer

Installing the firmware needs Chrome (or Microsoft Edge) on a Mac or Windows computer. Phones, tablets, Safari and Firefox can't do it.

Copy this address and open it in Chrome on your computer: app.sixonfive.com/receiver

What you need

  1. The SixOnFive receiver (the small M5Stack NanoC6 board).
  2. A USB-C cable that carries data (the one that came with it works; some charge-only cables don't).
  3. Chrome or Edge on a Mac or Windows computer.

Install

  1. Plug the receiver into the computer.
  2. Click Install receiver firmware, pick USB JTAG/serial debug unit (or the port that appears) in the list, then Connect.
  3. Keep it plugged in until it says it's done (about a minute).

Firmware . Check my receiver shows the firmware it has now, without changing anything.

The receiver firmware is for use with SixOnFive only. Installing needs a signed-in Head Coach or Staff, and each install is recorded. Don't copy, share, sell or take it apart (Terms of use).

After installing

  1. Unplug it from the computer. At the pool, power it from a USB battery or plug it into the scoring phone.
  2. In SixOnFive: Settings → Scoreboard receiver → Connect.
  3. The blue light: slow blink = waiting for a phone; double blink = phone connected; mostly on = reading the scoreboard.

If it doesn't install

  1. Unplug the receiver. Hold its button, plug it back in while holding, then let go. Click Install again.
  2. Try another cable or another USB port.
  3. On Windows, close any other program that may be using the receiver (Arduino, a serial terminal), then try again.

Still stuck? Email support@sixonfive.com.